(5) Each lift shall be crossed by at least one longitudinal bracing member in every 10 metres length of the scaffold. (4) Longitudinal bracing members shall be continuous and fixed at approximately 45° to the horizontal. (3) The joints in bracing members shall be lapped or spliced. (2) Every scaffold in a workplace shall be effectively braced by means of longitudinal and transverse bracing systems which shall extend from the base to the top of the scaffold. (1) It shall be the duty of the responsible person to ensure that the requirements of paragraphs (2) to (8) are complied with. (8) The ledgers of a timber scaffold in a workplace shall - ( a)īe spaced at vertical intervals of not more than 1.8 metres andġ6. (7) The ledgers of a metal scaffold in a workplace shall be spaced at vertical intervals of not more than 2 metres. (6) The foot of a standard of any frame or modular scaffold in a workplace shall be secured to a base plate so that it does not rest directly on the ground or supporting surface. (5) Where the floor or supporting structure is of sufficient rigidity to evenly distribute the load imposed upon it by the standard without causing any vertical displacement of the standard, the provision of a sole plate under the standard shall not be necessary. (4) Subject to paragraph (5), a standard of a scaffold in a workplace shall be placed on an adequate and secured sole plate in order that the foot of the standard does not rest directly on the ground or supporting surface, so as to prevent any vertical displacement of the foot. (3) No metal scaffold with standards spaced more than 2.5 metres apart shall be constructed or erected in a workplace unless it has been approved in writing by the Commissioner. In the case of a metal scaffold, subject to paragraph (3), spaced not more than 2.5 metres apart. In the case of a timber scaffold, spaced not more than 1.5 metres apart and (2) The standards of a scaffold in a workplace shall be - ( a)įixed sufficiently close together to secure the stability of the scaffold, having regard to all the circumstances 1 All of these can be controlled by compliance with OSHA standards.14. The Bureau of Labor Statistics' Census of Fatal Occupational Injuries (CFOI) reported 52 fatal falls to lower levels from scaffolding in 2020. Replaces traditional shipyard scaffolding. Provides general requirements for all scaffolds AND also includes information on specific types of scaffolding. OSHA has targeted the industry in its Strategic Plan to reduce injuries and illnesses and prevent fatalities. Shipyard work has traditionally been hazardous, with an injury-accident rate more than twice that of construction and general industry. Helps workers identify and control the hazards that cause the most serious scaffold-related injuries. Contains information that helps workers identify and control the hazards that cause the most serious construction-related injuries. Hazards are identified, as well as the controls that keep these hazards from becoming tragedies. Provides illustrated safety checklists for specific types of scaffolds. OSHA Fact Sheet (Publication 3722), (April 2014). OSHA Fact Sheet (Publication 3759), (November 2014).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |